Skip to exam content
TECHCLICK INFOSEC × ISC2 CISSP

CISSP Domain 4 Quiz

COMMUNICATION & NETWORK SECURITY
50QUESTIONS
75MINUTES
13%EXAM WEIGHT
70%PASS THRESHOLD
Topics: OSI/TCP-IP · Firewall types · IPSec AH/ESP · TLS 1.3 · IKEv1/v2 · VPN/ZTNA · Wireless WEP→WPA3 · EAP variants · Network attacks · DDoS · DNSSEC · 802.1X

CISSP practice test: what's covered

Questions in this Techclick bank50
Timer60 min
Techclick practice target70%
Official exam codeCISSP

Free CISSP sample questions

  1. A security architect is designing a network for a financial institution. The design includes a zone accessible to the internet, an internal corporate zone, and a management zone. The architect proposes using a single firewall with three separate interfaces to implement this architecture. Which statement BEST describes this design?

    • A. It is a true DMZ architecture and meets ISC2 best practice
    • B. It is a screened subnet that provides adequate separation with cost savings
    • C. A single firewall with three interfaces is not considered a true DMZ by ISC2 standards
    • D. The design is acceptable only if the firewall is a next-generation firewall
    Show answer

    Correct: C. ISC2 defines a true DMZ (screened subnet) as requiring TWO firewalls — one between the internet and the DMZ, and another between the DMZ and the internal network. A single firewall with three interfaces creates logical separation but represents a single point of failure and does not meet the dual-firewall DMZ standard. A: Incorrect — single-firewall three-interface design is explicitly not a true DMZ per ISC2. B: "Adequate separation" downplays the architectural weakness. D: NGFW capability does not change the architectural deficiency of a single control point. ISC2 Manager Mindset: The manager answer is architectural correctness, not cost optimization. ISC2 expects you to identify the contr

  2. During a penetration test, an attacker successfully diverts traffic between two hosts by sending unsolicited ARP replies that map the attacker's MAC address to a legitimate host's IP address. Which Layer 2 control would MOST effectively prevent this attack going forward?

    • A. Implement 802.1X port-based network access control
    • B. Enable Dynamic ARP Inspection (DAI) using the DHCP snooping binding table
    • C. Configure static ARP entries on all hosts
    • D. Deploy an IDS to detect gratuitous ARP packets
    Show answer

    Correct: B. Dynamic ARP Inspection (DAI) validates ARP packets against the DHCP snooping binding table. When an ARP reply arrives, the switch checks that the sender's IP-to-MAC mapping matches what DHCP snooping has recorded. Spoofed ARP replies that don't match are dropped, directly preventing ARP poisoning attacks. Incorrect options: A: 802.1X controls who can connect to the network but does not validate ARP packet content. C: Static ARP entries prevent poisoning but are operationally unscalable in large environments — ISC2 prefers automated controls. D: IDS detects but does not prevent — a compensating control, not the best primary prevention. ISC2 Manager Mindset: Prevention > Detection. When a cont

  3. An organization is evaluating VPN technologies for remote employees. The CISO is concerned about contractor laptops that may be compromised serving as pivot points into the corporate network. Which remote access approach BEST addresses this concern?

    • A. Deploy a full-tunnel IPSec VPN with endpoint compliance checks
    • B. Implement split-tunnel VPN to limit the attack surface
    • C. Use a Zero Trust Network Access (ZTNA) solution that grants application-level access only
    • D. Require all contractors to use a dedicated corporate-issued laptop
    Show answer

    Correct: C. ZTNA grants access to specific applications rather than placing remote users on the corporate network. Even if a contractor's device is compromised, the attacker cannot perform lateral movement across the corporate network because the device has no network visibility — only application-level access. This directly addresses the pivot-point concern. Incorrect options: A: Full-tunnel IPSec VPN places the contractor on the corporate network segment — a compromised endpoint still has lateral movement capability even with compliance checks. B: Split tunnel reduces internet traffic routing through VPN but does not limit network-level access once connected. D: Device provisioning addresses endpoint

  4. An organization uses IPSec to protect traffic between two sites. The VPN gateway at Site A is behind a NAT device. Site B uses a standard IPSec implementation. The tunnel fails to establish. Which configuration change would MOST likely resolve this issue?

    • A. Switch from ESP to AH to avoid IP header modification
    • B. Enable NAT-T (NAT Traversal) on both gateways using UDP port 4500
    • C. Configure IKEv1 Aggressive Mode instead of Main Mode
    • D. Request a static public IP at Site A to eliminate the NAT device
    Show answer

    Correct: B. NAT modifies the outer IP header. AH authenticates the entire IP header including source/destination IP, so any NAT translation breaks AH integrity checks. ESP does not authenticate the outer IP header. NAT-T encapsulates ESP packets inside UDP port 4500, allowing them to traverse NAT devices unchanged. Enabling NAT-T on both gateways resolves NAT compatibility for ESP. Incorrect options: A: Switching to AH would make the problem worse — AH is completely incompatible with NAT. C: Aggressive Mode in IKEv1 reduces messages from 6 to 3 but exposes identity information and does not resolve NAT issues. D: Eliminating NAT is impractical as an architectural change and not the protocol-level answer

  5. A security engineer is hardening DNS infrastructure for an enterprise against cache poisoning and unauthorized record manipulation. Which TWO controls BEST protect the DNS infrastructure? (Select TWO answers.)

    • A. Implement DNSSEC to enable cryptographic origin authentication and data integrity for DNS records
    • B. Deploy DNS-over-HTTPS (DoH) or DNS-over-TLS (DoT) to encrypt DNS queries between clients and resolvers
    • C. Disable recursive DNS queries on authoritative public-facing DNS servers
    • D. Increase the Time-To-Live (TTL) values across all public domain records
    Show answer

    Correct: A and B. DNSSEC adds digital signatures to DNS records. When a resolver receives a DNS response, it validates the cryptographic signature against the zone's public key. Tampered or injected DNS records will fail signature validation and be rejected, directly preventing cache poisoning attacks. Incorrect options: A: DoH encrypts DNS queries for confidentiality and prevents eavesdropping, but does not authenticate the DNS records themselves — a poisoned upstream resolver still returns bad data. C: Split-horizon DNS separates internal and external views but provides no integrity protection. D: Query rate limiting defends against amplification attacks, not cache poisoning. ISC2 Manager Mindset: DNSSEC =

Last updated:

CISSP practice test FAQ

Is this CISSP practice test free?

Yes. You can start, finish and score it for free, and download the Techclick practice certificate.

How many questions are in the Techclick CISSP practice test?

This bank has 50 original scenario-based questions with a 60-minute timer and a 70% Techclick practice target.

What is the official exam code and format?

The credential is ISC2 CISSP (Certified Information Systems Security Professional).

Are these real CISSP exam questions or dumps?

No. They are original practice questions written by Techclick. This is not the vendor's official exam and not leaked dumps.

Do I get a certificate?

Score 70% or higher to get a Techclick practice certificate and LinkedIn badge. It is not an official ISC2 certification.

What should I take after CISSP?

Related practice tests: CISSP, ISC2 CC, ISC2 CCSP, ISC2 CGRC, ISC2 SSCP (linked below).